parameter
Power supply 12... 24VDC
Ripple<10%
Minimum detectable velocity 5cm/s (along the longitudinal axis of the sensor)
Power consumption<2W
Detect patterns that are close to the moving target (not detected when away from the moving target)
Output delay of 1 second
Sensor installation location and ideal detection area range
Tilt the sensor inward by 10-30 degrees (depending on the width of the escalator) to avoid unnecessary area detection by the sensor. It is recommended that the vertical height above the ground be greater than 15CM or the sensor be tilted up 15 °. The sensor is installed inside the inner skirt below the armrest, as shown in the position on the right. When installing inside the metal skirt, open a circular hole with a diameter of 30mm on the skirt and fix the product according to the installation angle.
