MA-ETD24 amplifier
Signal output relay resistive load: 7A/250V ac
Output delay of 1-60 seconds (adjustable)
Detection mode for moving objects
Power supply voltage 12-36V DC
Power consumption<2W
Protection level IP20
Storage temperature -40 ℃~+80 ℃ (without condensation)
Working temperature -25 ℃~+65 ℃ (non condensing) EMC
Compliant with EMC 2014/30/EU standards
Terminal torque 0.4Nm
Shell material: polyphenylene ether
MS-24G-5H
Transmission frequency 24.125 GHz
Detection distance 2m (adjustable)
Transmission power<20 dBm EIRP
Detection mode for moving objects
Protection level IP67
Cable length 5m
Shell material flame retardant ABS
Compliant with EMC 2004/108/EC standards
Storage temperature -40 ℃~+80 ℃ (non condensing)
Working temperature -25 ℃~+65 ℃ (non condensing)
Installation instructions
1. Tilt angle: Horizontal -30 °~+30 °.
2. It is recommended that the vertical height above the ground be greater than 15CM, or tilt upwards by 15 °~20 °
3. The sensor is installed inside the inner skirt below the handrail.
When installing inside the metal skirt, open a 57 * 38mm square hole on the skirt, and then seal the square hole with a plastic plate to allow the sensor to detect passengers through the plastic square hole.
5. The sensor should cover the required detection area in front of the escalator. We recommend tilting the sensor inward by 10-30 degrees (depending on the width of the escalator) to avoid unnecessary area detection.
Quantity of one escalator: 2 MA-ETD24, 2 MS-24G-5H
