MA-DTD24 amplifier
Signal output relay resistive load: 7A/250V ac
Output delay of 1-60 seconds (adjustable)
Fault output resistive load: 125 V ac/1A
Detection mode for moving objects
Power supply voltage 24 V DC ± 30%
Withstand impulse voltage 2kV
Minimum detection speed 5cm/s (along the longitudinal axis of the sensor)
Power consumption<2W
Protection level IP20
Storage temperature -40 ℃~+85 ℃ (without condensation)
Working temperature -25 ℃~+65 ℃ (without condensation)
Compliant with EMC 2004/108EC standard
Terminal torque 0.4Nm
Shell material PPO
MS-24G-5 radar probe
Transmission frequency 24.125 GHz
Detection distance 2m (adjustable)
Transmission power<20 dBm EIRP
Detection mode for moving objects
Protection level IP67
Cable length 5m
Shell material flame retardant ABS
Compliant with EMC 2004/108/EC standards
Storage temperature -40 ℃~+85 ℃ (without condensation)
Working temperature -25 ℃~+65 ℃ (without condensation)
Installation instructions
1. Tilt angle: Horizontal -30 °~+30 °.
2. It is recommended that the vertical height above the ground be greater than 15CM, or tilt upwards by 15 °~20 °
3. The sensor is installed inside the inner skirt below the handrail.
When installing inside the metal skirt, a 30mm diameter circular hole is opened on the skirt, and then the circular hole is sealed with a plastic plate to allow the sensor to detect passengers through the plastic circular hole.
5. Two sensors jointly cover the required detection area in front of the escalator. We suggest tilting the sensor inward by 10-30 degrees (depending on the width of the escalator) to avoid unnecessary area detection by the sensor.
Quantity of one escalator: 2 MA-DTD24 and 4 MS-24G-5
